EN
89
This appliance is fitted with a safety cut-off which will operate if the fire
overheats (e.g. Due to blocked air vents). For safety reasons, the fire will NOT
automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at
least 15 minutes. Reconnect the supply to the mains and switch on the appliance.
SAFETY CUTOFF
TROUBLESHOOTING
CLEANING AND MAINTENANCE
Symptom Solution
No operation/ no fan. Check if put the electric plug into the socket.
Check for safety cut-off operation.
No fire effect light. Check the LED system by qualified electrician
Warning- Always disconnect from the mains supply before cleaning heater.
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT
use proprietary glass cleaners.
This product does not use a standard bulb for its flame effect. The appliance uses an
electronically controlled LED system to create the effect, therefor no parts need to be
replaced. There are no user-serviceable parts on this appliance. Under no circumstances
should the appliance be serviced be anyone other than a qualified electrician.
Disposal
At the end of the product’s serviceable life it should be disposed of thoughtfully
and safely in accordance with local authority regulations. The plug should be
Removed from the power supply cord and the power cord cut from the heater
To Next Page
Loading...
