INTRODUCTION
The model GL-650 UC, induction warmer is designed to offer fast, high quality warming
through natural solid surfaces such as granite. It is constructed of food service quality
stainless steel for commercial applications, and tinted tempered (safety) vitroceramic
glass. The unit requires induction ready pans to operate. The touch activated control
panel is fully sealed to prevent liquid intrusion. Controls include an on-off power
button, + and – buttons to raise and lower the temperature, or power level setting.
Specifications:
Model Electrical Plug
Configuration
GL-650 UC 120V, 50/60 Hz, 1 PH, 650W, 6A NEMA-5-15P
All models are required to be installed on a dedicated circuit rated not less than 25% over
the maximum current indicated for that model above, in accordance with NEC standards.
Plug ends have been appropriately installed to meet these requirements.
INSTALLATION
The
Induction Warmer
needs to be connected to a grounded outlet of proper
voltage of 120V, single-phase, 50/60Hz. DO NOT place the unit in a damp area or
near steam sources, or where heat from other equipment may affect the unit, by
raising its internal temperature. When positioning the appliance, make sure that the
bottom ventilation holes are not blocked. Maintain 2” clearance around the appliance.
Since the induction warmer may be installed in a counter, please make sure there is
adequate ventilation within the cabinet.
La cuisson par induction doit être connecté à une prise de terre de tension correcte de
208/240V, monophasé, 50/60 Hz. NE placez PAS l'appareil dans un endroit humide ou
à proximité de vapeur sources, ou où la chaleur provenant d'autres appareils peut avoir
une incidence sur l'unité, en augmentant sa température interne. Lors du
positionnement de l'appareil, assurez-vous que le bas orifices de ventilation ne sont pas
obstrués. Maintenir 2" de dégagement de chaque côté, à l'arrière et le dessus de
l'appareil.
To Next Page
Loading...