39
EBP28
In more detail . . .
Long term storage
NOTE: Risk of machine damage!
> If you are not going to use the machine for a while, remove the fuel from
the machine. This way, you will prevent a gumming-up of the engine and
of the grease pump.
> Store the machine in a dry place and far away from possible sources of
ignition such as ovens, gas thermostats, etc.
1. Empty the fuel tank (11) if you are not going to use the machine for an extended
period of time (more than 3 months) and before storing it for the winter.
2. Start the engine and let it run until the engine stops by itself (see “Starting the
engine”).
3. Let the engine cool down (approx. 5 min).
4. Disconnect the spark plug connector (6) and remove the spark plug.
5. Let a teaspoon of clean two-stroke engine oil run into the combustion chamber.
6. Pull the recoil starter handle slowly several times in order to coat the internal
components with the oil.
7. Ret only the spark plug and leave the spark plug connector (6) disconnected.
Transportation
1. Stop the engine and disconnect the spark plug connector (6) before transporting it
anywhere.
2. Attach transportation guards, if applicable.
3. Always carry the machine by its handle.
4. Protect the machine from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
5. Secure the machine to prevent it from slipping or falling over, loss of fuel, damage
and injury.
If you are transporting the machine in a vehicle:
> Let the machine cool down.
> Empty fuel tank (11).
> Secure the machine against slipping using bungee cords (not provided) and
vehicle’s transportation hooks.
Care and maintenance
To Next Page
Loading...