22
Use
Intended use
This product is intended for sanding the following materials: wood, plastic, metal,
llers as well as varnished surfaces. This product should not be used on other
materials or those harmful to health. It is to be used for dry operation only without
water or other cooling liquids.
Before you start
01
Protection
Controls
01
Speed dial
The proper belt speed can be pre-selected with the speed dial (8) as instructed in Fig. H.
The speed can also be changed during operation.
The required belt speed depends on the material being sanded and should be
determined by practical testing regarding removal efciency and surface quality.
02
On/Off switch & Lock-on button (Fig. I)
Mode Action Application
Instant Press the On/Off switch (4) Switch on the power tool.
Lock-on
Press the On/Off switch (4) fully, hold
it in position and press the lock-on
button (2). See Fig. I.
The power tool will run continuously
and be limited at a speed
preselected by speed dial (8). No
need to hold the switch after lock-on.
Off
Release the On/Off switch (4) for
instant mode, or press and release the
On/Off switch (4) for lock-on mode.
Switch off the power tool.
950W BeltSander MNL_EBS950_TPS_GB_V1_V20518_20180607.indd 22 6/7/18 10:23 AM
To Next Page
Loading...
