28
Use
Intended use
This product is intended for straight cuts in wood and similar material e.g. MDF and
chipboard, with the installed blade. The product must not be used for cutting logs.
The product must be used in an upright position only with the base plate lying at on
the workpiece. It may not be used upside down or as stationary product on a work
bench.
The supplied saw blade is only suitable for cutting wood and must not be used for
other materials.
Before you start
01
Protection
Controls
01
Cutting depth adjustment (Fig. D)
WARNING! Always switch the product off and disconnect it from power
supply before making any adjustments!
Always use the correct blade depth setting! The correct blade depth
setting for all cuts should allow approx. 50%-90% of the saw tooth height
to be visible below the material being cut!
Adjust the cutting depth according to your needs.
1. Place the product on a at surface and ensure its safe position.
1400W circular saw MNL_ECS1400_TPS_GB_V1_V20518_20180605.indd 28 6/5/18 3:24 PM
To Next Page
Loading...
