Erbauer ECSP41 - User Manual

Questions and Answers

A
Alan ComptonAug 5, 2025
Why my Erbauer Chainsaw engine does not reach maximum speed?
- C
  Crystal SullivanAug 5, 2025
  If your Erbauer Chainsaw engine isn't reaching maximum speed, the air filter or spark plug may be dirty and need cleaning. The distance from the electrode to the spark plug may be too great; in this case, set the gap between electrodes to 0.7 mm. Also, check that you are using the correct fuel mixture. If these steps don't resolve the issue, the carburetor setting may not be correct and should be adjusted by a dealer or authorized service center.
S
Sharon NguyenAug 10, 2025
What to do if Erbauer Chainsaw engine does not start?
- J
  Jenna MooreAug 10, 2025
  If your Erbauer Chainsaw engine isn't starting, the spark plug may be defective and need replacing. If the engine is too cold, follow cold starting procedures and set to anti-freeze mode if necessary. Conversely, if the engine is too hot, wait until it cools down, then follow warm starting procedures and check the standard/anti-freeze mode. If the problem persists, the carburetor setting may not be correct and should be adjusted by a dealer or authorized service center.
C
Chad GreenAug 15, 2025
Why is my Erbauer ECSP41 Chainsaw producing excess smoke?
- M
  Mr. Matthew WellsAug 15, 2025
  If your Erbauer Chainsaw is producing excessive smoke, it's likely due to an incorrect fuel or fuel mixture. Stop the engine, empty the fuel tank, and refill it with the correct fuel mixture.
V
vgrayAug 20, 2025
How to fix insufficient chain lubrication on Erbauer ECSP41?
- F
  Fred MasonAug 20, 2025
  To address insufficient chain lubrication on your Erbauer Chainsaw: 1. Check if the saw chain oil tank is empty and fill it up if needed. 2. Inspect the oiling port for clogs and clean it. 3. Verify that the saw chain lubrication setting is correct and increase it if necessary.
T
Tina BellAug 26, 2025
What to do if Erbauer ECSP41 Chainsaw chain starts before pressing the throttle?
- B
  Bryan ReyesAug 26, 2025
  If the chain on your Erbauer Chainsaw starts up before the throttle trigger is pressed, ensure that the chain brake is engaged. It's also possible that the idling speed is too high; in this case, press the throttle trigger slightly after starting. If the issue continues, have the carburetor adjusted by a dealer or authorized service center.
A
Amy DavisAug 30, 2025
Why Erbauer Chainsaw chain does not start?
- S
  Sara NewtonAug 31, 2025
  If the chain on your Erbauer Chainsaw isn't starting, check if the chain brake is engaged and disengage it.