Erbauer ECSP41 - Page 36

36
ECSP41
In more detail . . .
Starting the engine
DANGER! Risk of re!
> Due to any spilled fuel, the product can catch re.
> Wipe any spilled fuel up before starting.
> Start the engine a few metres away from the place where you have lled it.
DANGER! Risk of injury! If the chain brake is not engaged, the saw chain
starts up directly after the engine is started. Make sure the chain brake is
engaged before starting the engine!
NOTE: Risk of product damage!
Never twist the starter cord around your hand! Only pull on the handle!
Do not suddenly release the recoil starter handle! Allow the rope to return
slowly and in a controlled manner each time it is pulled!
NOTE: The break-in period! Do not use new product at full speed (full throttle
/ revolutions) for the rst 2 tank llings. All moving parts have to “bed in” during
the break-in period. The frictional resistances in the engine are greater during
that period. The engine develops maximum power after about 5 to 10 fuel
tank llings.
Engine cold start
1. Place the saw where it does not come into contact with any objects.
2. Engage the chain brake.
3. Press the primer (7) until the bubble is lled with fuel (6 times) (Fig. 19).
4. Set the choke (13) to CLOSE position (Fig. 20).
19
7
20
13
Operation