36
ECSP51
In more detail . . .
Operation
Check before starting:
1. Check the product, as well as accessories for damage before each use. Do not use
the product if it is damaged or shows wear.
2. Double check that accessories and the guide bar/saw chain are properly xed.
3. Check the fuel level and chain oil level, rell if necessary.
4. Always hold the product by its handles. Keep the handles dry and clean to ensure
safe support.
5.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
6.
Stop the engine immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before
putting it down.
7.
Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
NOTE: In some countries regulations dene at what time of the day and on what
special days products are allowed to be used and what restrictions apply! Ask
your community for detailed information and observe the regulations in order
to preserve a peaceful neighbourhood and avoid committing administrative
offenses!
Starting the engine
DANGER! Risk of re!
> Due to any spilled fuel, the product can catch re.
> Wipe any spilled fuel up before starting.
>
Start the engine a few metres away from the place where you have lled it.
DANGER! Risk of injury! If the chain brake is not engaged, the saw chain
starts up directly after the engine is started. Make sure the chain brake is
engaged before starting the engine!
NOTE: Risk of product damage!
Never twist the starter cord around your hand! Only pull on the handle!
Do not suddenly release the recoil starter handle! Allow the rope to return
slowly and in a controlled manner each time it is pulled!
Operation
To Next Page
Loading...
