Erbauer ELM18-Li - Operation and Use; Intended Use and Operation; Starting and Stopping the Mower; Adjusting Cutting Height

9
8
d. CAUTION! Do not touch a rotating cutting device.
e. Before use check the supply and extension cord for signs
of damage or aging. If the cord becomes damaged during
use, disconnect the cord from the supply immediately. DO
NOT TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY. Do not use the product if the cord is damaged or
worn.
OPERATION
a. Operate the product in daylight or in good articial light.
b. Avoid operating the product in wet grass.
c. Always be sure of your footing on slopes.
d. Walk, never run.
e. Mow across the face of slopes, never up and down.
f. Exercise extreme caution when changing direction on slopes.
g. Do not mow excessively steep slopes.
h. Use extreme caution when reversing or pulling the product
towards you.
i. Stop the cutting device(s) if the product has to be tilted for
transportation when crossing surfaces other than grass, and
when transporting the product to and from the area to be used.
j. Never operate the product with defective guards, or without
safety devices, for example deectors and/or grass catchers, in
place.
k. Start the product or switch on the product carefully according to
instructions and with feet well away from the cutting device(s).
l. Do not tilt the product when switching on the motor, except if
the product has to be tilted for starting. In this case, do not tilt it
more than absolutely necessary and lift only the part, which is
away from the operator.
m. Do not start the product when standing in front of the discharge
chute.
n. Do not put hands or feet near or under rotating parts. Keep
clear of the discharge opening at all times.
o. Never pick up or carry a product while the starter key is
inserted.
p. Stop the machine, and remove the disabling device. Make sure
that all moving parts have come to a complete stop
- Whenever you leave the product,
- Before clearing blockages or unclogging chute,
- Before checking, cleaning or working on the product,
- After striking a foreign object. Inspect the machine for damage
and make repairs before restarting and operating the product; if
the product starts to vibrate abnormally (check immediately)
- Inspect for damage,
- Replace or repair any damaged parts,
- Check for and tighten any loose parts.
MAINTENANCE AND STORAGE
a. Keep all nuts, bolts and screws tight to be sure the product is in
safe working condition.
b. Check the grass catcher frequently for wear or deterioration.
c. Be careful during adjustment of the product to prevent
entrapment of the ngers between moving blades and xed
parts of the product.
d. Always allow the machine to cool down before storing.
e. When servicing the blades be aware that, even though the
power source is switched off, the blades can still be moved.
f. Replace worn or damaged parts for safety. Use only genuine
replacement parts and accessories.
g. Wear strong work gloves when removing and re-assembling
the cutting device.