OPERATION
Important: This planer-thicknesser is intended
specifically for planning and thicknessing
operations on solid timber. When being thickened,
the contact surface of the work piece must be flat.
If working with bigger or heavier work-pieces it
is necessary to clamp the machine firmly to its
supporting bench or table. The machine is not
suitable for operation outdoors when raining or
in any damp environment. Any other use beyond
this scope is considered as failing to comply with
the machines intended purpose. The manufacturer
is not liable for any damage or injuries caused
as a result of this; the risk is borne solely by the
user.
The ON / OFF (NVR) switch (1) of machine is
located on the left side below
the yellow cover.
To switch the machine on: Lift the yellow cover
and press the green button “1”.
To switch the machine off: Press the red button
“0” or firmly close the cover.
The switch can be locked to prevent the machine
from being inadvertently switched on by folding
down the yellow cover.
This machine is equipped with an overload
switch (2) for motor running protection. Once
the overload occurs, the machine will stop
automatically. After a while, the overload switch
can be reset.
Warning: Operation of any power tool can
result in foreign objects being thrown into
the eyes which can result in severe eye injury.
Always wear safety goggles, it is also advisable
to wear ear protection particularly if using the
planer for extended periods.
For your own safety, read all of the safety
instructions in this manual and adhere to all
precautions before and during operation of the
planer thicknesser.
Before each use:
• Make sure all moving parts are free from
interference.
• Make sure blades are aligned and correctly
attached to cutter-head (See maintenance section
of this manual).
• Do not plug in the planer thicknesser unless the
To Next Page
Loading...
