NOTE: Completely screw the nozzles on the wand up to the complete lock.
(See picture)
Reconnect and restart the pressure wahser and depress the trigger on the
spray gun. If the pressure is still too high, repeat above items 1-4.
LUBRICATION
The pressure washer is designed with a permanent lubrication system.
Conventional oil check and oil changes are not necessary.
NOTE: A SMALL AMOUNT OF OIL LEAKAGE IS NORMAL.
WATER SCREEN
The pressure wsher is equipped with a water inlet screen to protect the pump.
CAUTION: If the screen is not kept clean, the flow of water to the
pressure washer will be restricted and the pump may be damaged.
To clean inner water screen, remove quick-connect and remove the filter
screen from the pump inlet.
Backflush screen to clean.
Replace screen and quick-connect immediately to prevent any foreign matter
from entering the pump.
NOTE:
LUBRICATION
NOTE:
WATER SCREEN
CAUTION:
1. Make sure that the pressure washer is turned off and that the power cord
is unplugged.
2. Make sure that the water supply is turned off, and that the trigger is
squeezed to depressurise the unit.
3. Separate the nozzle from the wand (Fig.12)
4. Clear the nozzle.
5. Flush the nozzle backwards with water.
6. Reconnect the nozzle to the wand.
!!
CAUTION
To Next Page
Loading...
