OPERATIONOPERATION
WARNING:
WARNING:
START-UP PROCEDURESTART-UP PROCEDURE
1. Make sure water supply is connected and turned on.
2. Make sure the unit is plugged in.
3. Release gun safety if locked. (Fig.3).
4. To allow air to escape from the hose,squeeze trigger on the gun until there
is a steady stream of water.
5. Remove any dirt or foreign matter from the gun outlet and the male
connector of the wand.
6. Insert the required wand into the gun's quick-connect coupling by pushing
firmly and twisting the wand 1/4 of a tum to lock into place. (Fig.4).
Make sure wand is locked.
NOTE:
Make sure wand is locked.
NOTE:
!!
WARNING
Fig.3
Fig.4
Do Not Switch the power onto the machine
Safety lock locked Safety lock
unlocked
Risk of injection or injury. Do not direct discharge
stream at persons or animals.
To Next Page
Loading...
