WORKING HINTS FOR YOUR ANGLE
GRINDER
If your power tool becomes too hot, run no load for
2-3 minutes to cool the motor.
Never start your angle grinder with the disc/ accessory
in contact with the workpiece.
Always start at no load to achieve maximum speed
then start working.
Do not force the disc to work faster, reducing the
Disc’s moving speed means longer working time.
When grinding, always work with a 30° to 40° angle
between disc and workpiece. Larger angles will cut
ridges into the workpiece and affect the surface
finish. Move the angle grinder across and back and
forth over the workpiece.
When using a cutting disc, never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc.
When cutting, only cut in the opposite direction to
the disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of the
cut slot.
Always ensure the workpiece is firmly held or clamped
to prevent movement.
To Next Page
Loading...