Fig. 5
1. HAND GRIP AREAS
Always hold your angle grinder firmly with both hands
when operating (See Fig.5).
2. ROUGH GRINDING
The best roughing results are achieved when setting
the machine at an angle of 30° to 40°. Move the
machine back and forth with moderate pressure. In
this manner, the workpiece will not become too hot,
does not discolour and no grooves are formed.
Warning! Never use a cutting disc for
roughing.
3. CUTTING
Warning: For cutting metal, always work with
the wheel guard for cutting.
When cutting, do not press, tilt or oscillate the
machine. Work with moderate feed, adapted to the
material being cut.
Do not reduce the speed of running down cutting
discs by applying sideward pressure.
The direction in which the cutting is performed is
important.
The machine must always work in an up-grinding
motion. Therefore, never move the machine in the
other direction! Otherwise, the danger exists of it
being pushed uncontrolled out of the cut.
To Next Page
Loading...
