240W 1/4 SHEET SANDER
the sanding nish. Start your sander before sanding
and turn it off only after you stop sanding. For the
best results, sand wood in the direction of the grain.
Do not start sanding without having the sandpaper
tted. Do not allow the sandpaper to wear away it
will damage the base-plate. The guarantee does
not cover base-plate wear and tear. Use coarse
grit paper to sand rough surfaces, medium grit for
smooth surfaces and ne grit for the nal surfaces.
If necessary, rst make a test run on scrap material.
Use only good quality sandpaper. The sandpaper
controls the sanding efciency, not the amount of
force you apply to the tool. Excessive force will
reduce the sanding fciency and cause motor
overload. Replacing the sandpaper regularly will
maintain optimum sanding efciency.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance. Your
power tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool. If the
supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied
persons in order to avoid a hazard.
To Next Page
Loading...
