Erbauer ERB704SSW - Page 23

ERBAUER 457MM SCROLL SAW ERB704SSW
breakage, do not turn the switch on while the
workpiece is against the blade.
- Slowly feed the workpiece into the blade by
guiding and pressing the workpiece down against
the table.
CAUTION: Do not force the leading edge
of the workpiece into the blade. The blade
will deflect, reducing accuracy of cut, and it may
break.
- When the cut is complete, move the trailing edge
of the workpiece beyond the drop foot. Turn the
switch OFF.
Fig. 15
9
RIP OR STRAIGHT LINE CUTTING (Fig. 15)
- Raise the drop foot by loosening the drop foot
lock knob.
- Measure from the tip of the blade to the desired
distance. Position the straight edge parallel to the
blade at that distance.
- Clamp the straight edge to the table.
- Recheck your measurements using the workpiece
to be cut and make sure the straight edge is secure.
- Position the drop foot against the the top surface
of the workpiece.
- Secure the drop foot in place by tightening the
drop foot lock knob.
- Remove the workpiece from the blade prior to
turning the scroll saw ON.
CAUTION: In order to avoid uncontrollable
lifting of the workpiece and reduce blade
breakage, do not turn the switch on while the
workpiece is against the blade.
- Position the workpiece against the straight edge
prior to touching the leading edge of the workpiece
against the blade.
- Slowly feed the workpiece into the blade, guiding
the workpiece against the straight edge and
pressing the workpiece down against the table.
CAUTION: Do not force the leading edge
of the workpiece into the blade. The blade
will deflect, reducing accuracy of cut, and it may
break.
- When the cut is complete, move the trailing edge
of the workpiece beyond the drop foot. Turn the
switch OFF.