Erbauer ERB704SSW - Troubleshooting

ERBAUER 457MM SCROLL SAW ERB704SSW
PROBLEM CAUSE SOLUTION
Breaking blades 1. Incorrect tension
2. Overworked (worn out) blade
3. Wrong blade being used
4. Twisting blade in wood
1. Adjust blade tension
2. Reduce feed rate or
replace blade
3. Use narrow blades for thin
wood, wider blades for
thicker wood
4. Avoid side pressure on
blade
Motor will not run 1. Defective cord, plug or outlet
2. Defective motor
1. Unplug saw, replace
defective parts
2. Repairs MUST be made
by a qualified technician.
Call Service dept. for
advice
Excessive vibration
(Some vibration is
inevitable when the
saw and motor are
running)
1. Improper mounting of saw
2. Unsuitable mounting surface
3. Loose table
4. Motor mount is loose
1. See proper assemble
instruction
2. Replace plywood
workbench surface with
solid lumber surface
3. Tighten bevel locking
lever
4. Tighten motor mount
screws
Blade runout 1. Insufficient blade tension
2. Dull blade causing excessive
force to be used at workpiece
1. Increase blade tension
2. Renew blade and correctly
tension
TROUBLE SHOOTING