Erbauer ERB704SSW - Page 5

ERBAUER 457MM SCROLL SAW ERB704SSW
12. Secure work.
- Where possible use clamps or a vice to hold the work. It is safer than using your
hand.
13. Do not overreach.
- Keep proper footing and balance at all times.
14. Maintain tool with care.
- Keep cutting tools sharp and clean for better and safer performance. Follow
instructions for lubrication and changing accessories. Inspect tool cord periodically
and if damaged have them replaced by an authorised service facility. Inspect
extension cords periodically and replace if damaged. Keep handles dry, clean and
free of oil or grease.
15. Disconnect tools.
- When not in use, before servicing and when changing accessories such as blades,
bits and cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches.
- From the habit of checking to see that keys and adjusting wrenches are removed
from the tool before turning it on.
17. Avoid unintentional starting.
- Ensure switch is in the “off” when plugging in.
18. Use outdoor extension leads.
- When tool is used outdoors, use only extension cords intended for outdoor use
and so marked.
19. Stay alert.
- Watch what you are doing. Use common sense. Do not operate tool when you are
tired.
20. Check damaged parts.
- Before further use of the tool, it should be carefully checked to determine that it
will operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting and any
other conditions that may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorised service centre unless
otherwise indicated in this instruction manual. Have defective switches replaced
by an authorised service facility. Do not use the tool if the switch dose not turn it
on and off.
21. Warning.
- The using of any accessory or attachment other than those recommended in this
instruction manual may present a risk of personal injury.
22. Have your tools repaired by qualified person.
- This electrical tool complies with the relevant safety requirements. Repairs should
only be carried out by qualified persons using original spare parts, otherwise this
may result in considerable danger to the user.