Erbauer ERD18-Li - Tuning and Station Management

19
FINDING NEW STATIONS (DAB)(L)
From time to time, new DAB radio stations may become available. Or you may have
moved to a different part of the country. In this case you may need to activate your radio
to scan for new stations. Press the
button for 2 seconds, your radio will perform a
full scan of the DAB frequencies. You can also briey press the MODE button or the
Button to stop auto scanning. As new stations are found, the station counter on the right
side in the display will increase and stations will be added to the list.
FM OPEARATION MODE
Press the MODE button until FM is highlighted.
Manual tuning:
Briey Press the
or button to set the desired frequency. Each press will
increase or decrease the frequency by 0.05MHz. The frequency is shown on the display.
Scan Tuning:
Press the
or button and hold for 2 seconds, the tuner frequency will increase
to seek the rst radio station with strong signal and stop at that station. The frequency is
shown on the display. The right arrow button
may be pressed for 2 seconds again to
continue seeking a radio station at higher frequencies. The left arrow button
may be
pressed to seek radio stations at lower frequencies.
STORING STATIONS (DAB AND FM)
To store radio stations in preset list (M1)
- Tune to the current radio station and press the preset list button
for 2 seconds
to enter “Preset Store”
- Press the
or button or rotate knob to select the stored location, e.g.10
- Press the
button to save it, P10 is shown on the display.
NOTE:
You can store up to 10 radio stations.
If you select a stored location that is already lled, the station will be
replaced by the station you are listening to.
To recall the selected stations
- Press the preset list button
to enter “Preset Store”
- Press the
or button or rotate knob to nd the selected radio station, e.g.10
- Press the
button to conrm, P10 will be played.
To store and recall stations in preset memories quickly (M2)
Additionally, the unit also provides 5 memory presets (1-5) for each DAB/FM waveband
to be stored and recalled quickly.
To store the current radio station, press and hold the selected preset button (1-5) until the
preset number is shown on the display. The station is then stored in the selected preset
button.