Erbauer ERD18-Li - System Menu Setting

20
Repeat this procedure for the remaining presets. Stations stored in the preset memory
can be overwritten by following the procedures described above.
To recall stations from the preset memories, briey press the selected reset button while
the unit is in radio mode. The preset number and station frequency will appear on the
display.
SYSTEM MENU SETTING
In any mode, press the MODE button and hold on for 2 seconds to enter system menu
setting. Briey press the MODE button to return last function interface.
FACTORY RESET (N1)
If your radio fails to operate or some digits on the display are missing or incomplete,
carry out the following procedure.
- Press the MODE button to enter “System”
- Press the
button to enter “Factory Reset”
- Press the
button to enter “Yes or No”
- Press the
or button or rotate knob to select Yes or No and press
the
button to conrm the setting. After selecting Factory Reset/Yes, your radio will
be switched off automatically.
SW Version (N2)
The software display cannot be altered and is just for your reference.
- Press the MODE button to enter “System”
- Press the
button to enter “Factory Reset”
- Press the
or button or rotate knob to nd “SW Version” and press the
button. The software version will show on the display.