18V MULTI TOOL ERI616HTL
NOTE: Not all above list accessory is included, the
including accessory please refer accessory list, if
you use others accessories please buy well know
brand accessories.
NOTE: When plunging and sawing use a slight
pendulum motion, to allow sufcient chip removal.
The saw blade lasts longer if the wear is distributed
evenly. To ensure an even distribution, loosen the
saw blade, rotate it and retighten rmly.
Cut/Sand with a constant movement and light
pressure.
Heavy pressure does not increase the cut/removal
rate – the accessory merely wears faster.
Excessive use and heat build up drastically reduces
the life of saw blades.
DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please
recycle or dispose of the battery pack
properly. This battery pack contains Lithium
batteries. Consult your local waste authority for
information regarding available recycling and/or
disposal options. Discharge your battery pack by
operating your tool, then remove the battery pack
from the tool housing and cover the battery pack
connections with heavy-duty adhesive tape to
prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.
WORKING HINTS FOR YOUR TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds. Always
keep the blade sharp.
Always ensure the workpiece is rmly held or
clamped to prevent movement.
Any movement of the material may affect the quality
of the cutting or sanding nish.
Start your tool before working and turn it off only
after you stop working.
Do not start sanding without having the sandpaper
tted.
Do not allow the sandpaper to wear away , it will
To Next Page
Loading...
