18V BRUSHLESS COMBI DRILL ERI691COM
pressure to elongate a hole.
TUNGSTEN carbide drill bits should
always be used for concrete and
masonry. When drilling in metal, only use
HSS drill bits in good condition. Always use a
magnetic bit holder (not included) when using
short screwdriver bits. When screw-driving,
apply a small quantity of liquid soap or similar
to the screw threads to ease insertion.
10. LED LIGHT INDICATOR
Before operation, the LED light will be activated
when the On/Off switch is slightly depressed, and
will turn off after the On/Off switch is released.
The tool and battery are equipped with a protection
system. When the LED Light is quickly ashing
and turn off, the system will automatically cut off
power to the tool to extend battery life.
The tool will automatically stop during operation if
the tool and/or battery are placed under one of
the following conditions:
• Overloaded: The tool is operated in a manner that
causes it to draw an abnormally high current. In
this situation, release the Trigger Switch on the tool
and stop the application that caused the tool to
become overloaded. Then pull the Trigger Switch
again to restart.
• Overheated: Under the condition above, if the
tool does not start, the Tool and Battery are
overheated. In this situation, let the Tool and
Battery cool before pulling the Trigger Switch
again.
• Low battery voltage: The remaining Battery
capacity is too low and the tool will not operate. In
this
situation, remove and recharge the Battery.
WARNING: To turn on the light, press the On/
Off switch and make sure the Forward/
Reverse Rotation Control is on right/left
position.
11. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please
recycle or dispose of the battery pack
properly. This battery pack contains Lithium
batteries. Consult your local waste authority for
To Next Page
Loading...
