EasyManua.ls Logo

ergolet Luna User Manual

ergolet Luna
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
lift the world
Teknisk dokument / Udskiftning af batteri UK gælder for Luna / Dato 2004.10.01 / Version 1
Replacement
guide
Batteries
To replace Luna batteries you will need the following tools:
ü Side cutters
ü Screwdriver PZ 1x 75 (Philips type)
ü Hexagonal (Allen) key 2 mm
Run the strap approx. 1meter out before commencing the
replacement.
Turn the Luna unit around so that the bayonet side is upward again.
Remove the small screw (a) (M3 x 5) which holds the print card, cut
the wire ties holding the print card and battery.
Carefully pull the print card upwards until the large plug next to the
fuse can be seen. Press the holder and remove the plug(b).
Det gamle batteri kan nu fjernes.
Battery set: xxxxxxx
Remove Luna from the track, lay it on a table with the bayonet side
up.
Activate the emergency stop, remove the hand control from the
Luna cassette.
Unscrew the screws from the plastic bracket around the bayonet
inlet (4 pcs.)
Pull up on the lid (shell) at the side foils to remove it.
Carefully remove the side foils from their position in the lower shell.
Remove the lower lid (shell) in the same way as the upper lid.
The new velcro and ties to hold the battery are mounted.
See procedure for replacing batteries on the back of this guide
b
Question and Answer IconNeed help?

Do you have a question about the ergolet Luna and is the answer not in the manual?

ergolet Luna Specifications

General IconGeneral
Brandergolet
ModelLuna
CategoryLifting Systems
LanguageEnglish

Summary

Luna Battery Replacement Guide

Required Tools for Battery Replacement

Lists essential tools like side cutters, screwdriver, and hex key for battery replacement.

Initial Disassembly Steps

Instructions for detaching the Luna unit, removing the lid, side foils, and lower shell.

Removing the Old Battery

Steps to remove the battery, including unscrewing, cutting ties, and disconnecting the plug.

Reassembly and Testing

Battery Reassembly and Wiring

Procedure for correctly installing the new battery, bundling wires, and replacing shells.

Post-Replacement Function Checks

Verifies functions of side foil, hand control, and charge indicator after replacement.

Related product manuals