24
Environmental protection
information
Please read and observe ...
Installation site
The tanning device must be installed on a flat, even surface.
When setting up Profi tanning devices up to 450 kg, you must ensure that
floors and ceilings in areas used for industrial purposes are designed for
a loading of 1500 N/m
2
.
The load bearing capability of ceilings with wooden joists must be dem-
onstrated in detail.
Tools and outfitting
The following tools are required for the dismantling / assembly work:
– Cross-headed screwdriver 2
– Double ended SW 17 and 13 mm
– 4 mm Allen-key (Ergoline key 84500, 83828)
– Canopy bag (190000130)
– Support aid rear wall (701529)
– Lengthening piece (15720613)
To Next Page
Loading...
