25
Operation
Automatic switching off system (Advanced Control Feature)
Standby mode
The automatic switching off system ensures that a warning signal sounds
and the face tanner's LEDs illuminate if, for example, a user's hand towel
is left close to the face tanner.
The tanning unit will not start until the hand towel is removed. Press the
START / STOP button and the tanner will return to standby mode.
Operating the tanner
The automatic switching off system ensures that a warning signal sounds
and the face tanner's LEDs illuminate if, for example, a user's hair or
hand towel is too close to the face tanner.
The tanner will be switched off after a few seconds if the object is not re-
moved.
The face tanner can be switched back on after the cooling down time has
expired (approx. 1 minute) by pressing the -button.
Note:
The face tanner will run up to the highest level automatically
after being switched back and can then be switched down to
a lower level as required.
...
To Next Page
Loading...
Need help?
General
