Ergotron WorkFit-P - Installation Procedures; Step 1: Mounting the Workstation

4 of 9
888-45-307-G-01 rev. F • 11/13
1
4 mm
1x
1x
1x
4 mm
b
c
d
a
1x
1/4”
8mm
0.5"-2.5"
(13-64mm)
0.78"-2.56" (20-65mm)
0.78"-1.38" (20-35mm) 1.18"-2.56" (30-65mm)
ENGLISH
Set-up Steps
Warning: Because mounting surface materials can vary widely, it
is imperative that you make sure mounting surface is strong enough to
handle mounted product and equipment.
CAUTION: Bolt must be
centered in hole.
CLAMP GROMMET HOLE
DESK THICKNESS