Ergotron WorkFit-TLE - Mounting and Pinch Point Safety

828-100
DO NOT place hands on or near support bars. Pinch points are
created during lifting and lowering the worksurface. Failure to
follow these instructions may result in serious personal injury.
WARNING
PINCH POINT
Safety
WarningBecausemountingsurfacematerialscanvarywidelyitisimperativethatyoumakesuremountingsurfaceisstrongenoughto
handlemountedproductandequipment
Caution
ToavoidthepotentialtopinchcablesitisimportanttofollowthecableroutinginstructionsinthismanualFailuretofollowtheseinstructions
mayresultinequipmentdamageorpersonalinjury
Safety
Warning: Impact Hazard! Worksurface under tension. Moving Parts can Crush and Cut.
Raise worksurface to top of vertical adjustment BEFORE removing equipment.
Failure to heed this warning may result in serious personal injury and or property damage!
Warning: Impact Hazard! Moving Parts can Crush and Cut.
Raise this product to its full up position before lifting o the desk.
Two people are required to lift this product o the desk.
Do not tip this product on its side or upside down. This product must remain upright at
all times.
Failure to heed this warning may cause unintended motion of the lift mechanism
resulting in possible serious personal injury and or property damage!