Installing and Upgrading the Software
22
3/1531-HSD 101 41 Uen E 2007-08-13
ESN212# management vlan 246
5. Configure IP parameters. In the following example the following
parameters are set:
− IP address 172.30.10.100
− Subnet mask 255.255.255.0
− Trap receiver 172.30.10.10
− SNTP server 172.30.10.10
− Default gateway 172.30.10.1
Note that Trap receiver, SNTP server and default gateway must be
configured even though they might be overwritten by a management
system (PEM for example).
esn212# boot mode manual ip address 12.30.10.100
255.255.255.0 trap receiver 12.30.10.10 sntp server
12.30.10.10 def gateway 12.30.10.1
6. Restart the ESN212:
esn212# restart
Note that the settings are automatically saved. It is therefore not necessary
to save them manually before the restart.
8 Installing and Upgrading the Software
Both application and boot SW of the ESN212 and EDN612 is upgraded
from the ECN330 Ethernet Controller Node (CLI) or from a management
system. See the management system documentation or the ECN330 User
Guide for instructions.
To Next Page
Loading...