Connecting Devices to the FWT
18 Fixed Wireless Terminal: G32 and G36 models
fixed line. You cannot, for example, receive or originate a telephone call
while sending or receiving a fax.
Warning: In order to avoid GSM interferences (noise), place the
FWT at least three (3) meters (horizontal) away from electronic
devices, including the telephone equipment connected to the FWT,
or other household electronic devices such as televisions or radio
receivers. The difference in height should be at least 2 meters
(vertical). This is not necessary if you use telephone devices that
fulfill the Immunity Characteristics settled by the IEC CISPR-24
standard. In this case, a minimum security distance of 20 cm is
recommended.
Connecting the FWT to a PBX
This feature is only available for the FWT G36 model. The G36 FWT is
designed to provide a telephone line (RJ11 connector) that behaves in the
same way as an analog trunk.
Generic requirements
The PBX should meet the following generic requirements for G36 FWT
connectivity:
• The PBX must provide analog trunks.
• One position of the trunk must be assigned to each G36 FWT.
• The trunk card must support either Busy Tone Detection (BTD)
or Polarity Reversal Detection on answer and release.
To Next Page
Loading...