Connecting Devices to the FWT
Fixed Wireless Terminal: G32 and G36 models 21
Receiving a fax
Incoming faxes are received in the same way as using a fixed line.
Note: If you have a SIM card that does not support separate voice
and fax numbers, the FWT does not recognize the type of incoming
call. This means that the calling party will have to inform you each
time a fax is about to be sent. In this case, dial *9901# to prepare
your FWT to receive a fax call Dial *9903# to change back to voice.
Connecting PCs
Analog modems connected to the FWT telephone line interface works in
the same way as if they were connected to a fixed line. In this way, you
can use your PCs standard modem to make data calls (Internet browsing,
e-mail, etc.) through the FWT line interface. When your PC is connected
to the FWT via the USB cable it acts as a modem
To be able to send and receive data calls, you need:
• A PC equipped with an analog modem and the appropriate
computer program (Web Browser, E-mail, etc).
• A SIM card that supports data transmission over the GSM
network.
Note: If you do not have a modem in your PC, the FWT can be
configured to act as a modem. This requires the installation of the
FWT modem drivers on your PC.
The FWT should be pre-configured with the settings from your network
operator. For detailed information on the FWT data configured settings,
please consult your distributor or network operator.
You can choose between the following two connection methods:
EDGE/GPRS data
EDGE/GPRS data allows you to be always online as you are not charged
for the connection time but for the amount of data that you exchange.
You need a SIM card that supports EDGE or GPRS. Please contact your
network operator for charging subscription details.
EDGE/GPRS data access type allows you to make outgoing connections
only, usually to connect to the Internet. Your GSM network operator
provides you with an Internet connection as part of the EDGE/GPRS
service.
Warning: The EDGE /GPRS data communication service has to be
registered with your network operator. Otherwise, the network will
not accept EDGE connections.
To Next Page
Loading...