Connecting Devices to the FWT
22 Fixed Wireless Terminal: G32 and G36 models
If your SIM card supports EDGE/GPRS, your network operator will supply
you with a user name and password in order to access the EDGE/GPRS
network if necessary, and optionally, to improve the Internet connection, a
DNS address and a proxy address. All these settings will allow you to
configure the Dial-up Networking program in your PC in order to establish
an EDGE/GPRS connection.
Note: This procedure is similar to the way you configure an Internet
connection from a specific ISP (Internet Service Provider).
If your network operator has provided you with an installation guide,
please follow the instructions included in the guide.
Otherwise, the present manual explains the installation process. As the
Dialup Networking is different for Windows™ NT/2000, Windows™ XP
and Windows™ 2003 three separate descriptions are provided. Please
refer to the topic PC Data Configurations documented on page 4 for more
detailed information.
If you encounter problems during installation, please contact your
distributor or network operator.
GSM data
GSM data is charged by time, this means you pay for the time you are
connected. You need a SIM card that support GSM data.
The GSM data access type allows you to make both incoming and
outgoing data calls, in the same way as with a fixed line. Therefore, you
can connect to the Internet using the same ISP (Internet Service Provider)
that you would use with a fixed line.
Note: You will not be able to make or receive other calls while a
GSM data communication is established.
The SIM card must support GSM data. The network operator does not
need to supply any specific information, and it is your ISP who provides
you with the user name, password and installation information in order to
establish an Internet connection. Please contact your ISP for installation
instructions.
Note: Your PC should be configured in the same way as if using a
fixed line, please check also that are you using the latest driver for
the modem.
Tip: If you already have an Internet connection configured for a
fixed line, you do not need to make any changes, just connect your
PC to the FWT line (RJ11) instead of a fixed line.
Note: If your modem is an old model and it is not able to send the
CNG tone, you should include *02* before the destination number
(B-number) in order to indicate to the FWT that the call to be made
is a data call (Example: *02*B-number). This is usually not
To Next Page
Loading...