Registering a Mobile Phone to the KRD 901 54 – Pairing
In order to make the first call through the KRD 901 54, the Mobile Phone has to be
registered to the KRD 901 54 – the so-called pairing or bonding.
After a reset i.e. activation of the Reset button, it is necessary to redo the pairing.
The Mobile Phone must be Bluetooth enabled.
Please refer to instructions regarding “Bluetooth wireless” in the user’s
guide of the actual Mobile Phone in use.
Pairing can take place in two cases. Member pairing is a permanent pairing to the
KRD 901 54 access point in the premises where the Mobile@Home solution is installed.
Guest pairing is a temporary pairing a Mobile Phone to the KRD 901 54 access point e.g.
during a visit in a premises of another owner (“Member”). The guest pairing infor-
mation is removed from the pairing list 24 hours after the last call was completed.
Member pairing
Prepare the KRD 901 54 for Member pairing by pushing the button (Pairing button) on
the rear panel of the KRD 901 54 once; see Figure 6.
The Member LED will flash fast green.
or
Guest pairing
Prepare the KRD 901 54 for Guest pairing by double pushing the button (Pairing button)
on the rear panel of the KRD 901 54; see Figure 6.
The Guest LED will flash fast green. Guest pairing is pairing a Mobile Phone when
visiting “another” home with an KRD 901 54 access point (AP).
Figure 6 Press the Pairing button once for Member pairing
and twice for Guest pairing
6
To Next Page
Loading...
