Ericsson MINI-LINK TN - Concluding Routines; Checking Active Alarms; Checking Current SBL; Handling Faulty Units

Replacing an NPU1 C with an NPU1 D
4.4 Concluding Routines
Perform the following concluding routines before leaving the site.
4.4.1 Checking Active Alarms
To check active alarms:
1. In MINI-LINK Craft, in the Management Tree, right-click the unit.
2. Click Alarms.
3. If alarms are active on the Alarms and Status page, perform corrective
actions for each active alarm as described in Alarm Descriptions, Reference
[2].
4.4.2 Checking Current SBL
To check Software Baseline (SBL):
1. In MINI-LINK Craft, in the Management Tree, right-click the NE.
2. Point to Tools, Software Upgrade and click Software Upgrade.
3. On the Software Upgrade page, identify the current SBL running on the
NE.
4. If the current SBL is not the desired SBL, upgrade the SBL by following the
instructions in Upgrading or Downgrading a SW Baseline, Reference [11].
4.4.3 Handling Faulty Units
If the old unit was faulty, follow the instructions in Handling Faulty Equipment,
Reference [5].
15107/1543-HRA 901 20-V11 Uen B | 2015-12-01