Ericsson RBS 2308 - Page 74

RBS 2308 and RBS 2309 User’s Guide
P011353A
Figure 25 Earthing Outer Shield Only
Connecting Optical Ethernet for IP-based Transmission
1. Follow the instructions in section Routing Transmission Cables in chapter
Reconfiguring the RBS for IP Transmission.
2. Continue with Section 5.4.7 Installing the GPS Solution Synchronization
(Optional) on page 66.
Connecting Electrical Ethernet for IP-based Transmission
1. Follow the instructions in section Routing Transmission Cables in chapter
Reconfiguring the RBS for IP Transmission.
2. Continue with Section 5.4.7 Installing the GPS Solution Synchronization
(Optional) on page 66.
5.4.7 Installing the GPS Solution Synchron izatio n (Optional)
For information about GPS solution synchronization connections, see:
GPS Solution Synchronization,
Installation Instructions
EN/LZT 720 0435
5.4.8 Installing the RRU
This section describes how to install the Remote Radio Unit (RRU).
Note: To avoid damage, do not place the RRU on its connectors, see Figure
below.
66
EN/LZT 720 0027 Uen R8A 2006-06-27