Installation Instruction
7.
Put back the bottom cover plate and tighten the screws.
8.
Position the DC filter and tighten the screws.
9.
Connect the earth grounding cable to the RBS as shown in the figure below.
Tighten the nut to a torque of 15 Nm.
Figure 8 Earth Grounding Cable
10.
Connect the earth grounding, temperature sensor, and signal cables to the
RBS.
11.
Connect the battery cable to EXT BATT.
14 1/1531-COH 109 2073 Uen H 2006-11-06
To Next Page
Loading...
