Procedure
P016851A
Figure 44 Wire Connections Variant 2
9. Attach the correct wires to the appropriate connectors in the terminal block.
Note: See the Site Installation Documentation for more information on
the transmission connections.
Figure 45 OVP Module Connection Points
10. Pull the cable back through the cable gland and clamp it by screwing the
cable gland together from underneath. See figure below.
Note: Make sure that the outer screen is in contact with the earth
grounding of the cable gland.
39
1/1531-COH 109 2073 Uen H 2006-11-06
To Next Page
Loading...
