Installing RBS
Appendix B – Install Alarm Cable
2
3
4
1
100
5
25
(mm)
1. Strip the insulation from the alarm cable and twin the wires in pairs, as shown in the illustration
above.
2. Connect each wire to the 6x2 pole alarm connector. The illustration shows how the wire-pairs
connect to the alarm connector.
3. Connect the alarm connector to the RBS.
4. Fasten the screws with a slot headed screwdriver 2.5x5.0 mm.
10
25/1531-LZA 701 6001 Uen H | 2013-11-14
To Next Page
Loading...
