User Manual
38
Connect the quick connector to the sampling
port on the Control panel
Break off the 2 ends of the tube by inserting
them into the plastic pump end.
Connect the tube to the plastic pump following
the direction of the arrow printed on the tube
38
Soak a roll up piece of paper in a
container placed inside the enclosure.
Pour a sufficient quantity of the chemical
to be tested on the paper.
Break off the 2 ends of the tube by inserting
them into the designed hole of the
professional pump
Connect the tube to the professional pump
following the direction of the arrow printed
on the tube
To Next Page
Loading...
