Need help?Do you have a question about the ero electronic ELK Series and is the answer not in the manual?
Identify the controller model and check its ordering code or quick code configuration.
Provides physical dimensions and views of the ELK and ETK controller models.
Steps for mounting the controller on a panel, including cut-out sizes and spacing.
Details of hardware configurations available for ELK and ETK models based on the ordering code.
Diagram showing terminal connections for the ELK controller.
Diagram showing terminal connections for the ETK controller.
Configuring various sensor inputs like Thermocouple, RTD, mV, and Voltage.
Information on RS232 and RS485 communication interfaces and connections.
Guide for setting up a new controller using Quick Configuration codes.
Overview of front panel layout, buttons, and indicator beacons.
Explanation of how to switch between Auto, Manual, and Off operating modes.
Parameters accessible for daily operation without a passcode.
Procedure for accessing the second level of operator parameters using a security code.
Details on setting up and configuring process alarms, including alarm types and indications.
Description of the internal timer operation modes: Dwell, Delayed, and Soft Start.
Specifications for Thermocouple, RTD, Linear, and Logic inputs.
Specifications for Relay, Logic, and DC outputs.
Details on interface types, protocols, addresses, and baud rates.
General safety compliance and EMC directives for the controller.
Precautions for ensuring electromagnetic compatibility during installation.
Guidelines for servicing, repair, cleaning, and handling precautions.
Measures to prevent damage from electrostatic discharge to components.
Explanation of safety symbols and requirements for qualified installation personnel.
Safety measures for live parts, sensors, wiring, and enclosures.
Requirements for power isolation, overcurrent protection, and voltage ratings.
Excluding conductive pollution and managing atmospheric conditions within the enclosure.
Recommendations for grounding the temperature sensor shield for enhanced safety.
Strategies to prevent over-heating in the process control system and protect machinery.
Guidelines for routing wires to minimize electrical noise interference and ensure signal integrity.
General| Brand | ero electronic |
|---|---|
| Model | ELK Series |
| Category | Controller |
| Language | English |
To Next Page
