Need help?Do you have a question about the ero electronic MKC and is the answer not in the manual?
Illustrates rear terminal block wiring for PKC and MKC models.
Details thermocouple input wiring and associated notes for accurate measurements.
Explains Resistance Temperature Detector input wiring and important notes.
Covers wiring for mA, mV, and V linear input signals, including important notes.
Explains the wiring and functionality of TRIAC output types.
Provides step-by-step instructions for instrument maintenance and cleaning.
Guide to configuring the main input type using J103 settings.
Instructions for setting the auxiliary input type via J102 configuration.
Procedure for selecting output types for outputs 3 and 4 using J204/J205.
Details the general notes and procedures for setting security codes on parameters.
Provides instructions for modifying the instrument's configuration parameters.
Covers selection of main input types like Thermocouple, RTD, and their respective ranges.
Configures the primary function of output 1, such as control or alarm.
Sets the operational function for output 3, including servomotor control.
Specifies the type of servomotor control (e.g., close loop, open loop).
Configures split range functionality for dual control outputs.
Enables or disables the automatic control optimization function.
Selects the control algorithm type: PID or PI.
Covers types, input, and parameters for servomotor output control.
Describes functions for analog outputs 5 and 6, including retransmission.
Explains how to load default values for run time parameters.
General| Brand | ero electronic |
|---|---|
| Model | MKC |
| Category | Controller |
| Language | English |
To Next Page
