ero electronic MKC - On the Auxiliary Input

Gr.Hd
101
- Maximum value of proportional band
calculated by SMART algorithm - [r.L02]
This parameter is available only when smart function is
configured (“Sñ.Fn” [C.G01] = “Enb”)
Range: from “Pb.Lo” [r.L01] to 999.0%
NOTE: The resolution on “Pb.Hi” value will be equal to 0.1% up
to 10.0% and 1% up to 999.0
- Minimum value of integral time calculated by
SMART algorithm - [r.L03]
This parameter is available only when smart function is
configured (“Sñ.Fn” [C.G01] = “Enb”)
Range: from 00.01 mm.ss to “ti.Hi” [r.L04].
- Maximum value of integral time calculated by
SMART algorithm - [r.L04]
This parameter is available only when smart function is
configured (“Sñ.Fn” [C.G01] = “Enb”)
Range: from “ti.Lo” [r.L03] to 20.00 mm.ss
- Relative gain of the secondary output
calculated by SMART algorithm - [r.L05]
This parameter is available only when smart function is
configured (“Sñ.Fn” [C.G01] = “Enb”) and a secondary control
output (without split range) is configured.
Range: OFF = Smart algorithm does not calculate “r.Gn”
[r.d06] value.
On = Smart algorithm calculates “r.Gn” [r.d06] value.
Xkc-1-C0.P65 5/29/02, 11:59 AM101