ero electronic MKC - Configuration Group 4 [C.Gxx]; Smart Function - [C.G01]; Control Action Type - [C.G02]

CnF. 4
50
CONFIGURATION GROUP 4 [C.Gxx]
AUXILIARY CONTROL CONFIGURATION
- Smart function - [C.G01]
This parameter will be available only when at least one control
output is configured
Range: dIS = Smart function disabled
Enb = Smart function may be enabled
- Control action type - [C.G02]
This parameter will be available only when at least one control
output is configured
Range: Pid = The process is controlled by PID actions
Pi = The process is controlled by PI actions
- Manual function - [C.G03]
This parameter will be available only when at least one control
output is configured
Range: dIS = Manual function disabled
Enb = Manual function may be enabled
- Output value for AUTO to MAN transfer
- [C.G04]
This parameter will be available only when at least one control
output is configured and manual function is enabled (“ñAn.F”
[C.G03] = “Enb”)
Range: - from 0.0 to 100.0 % of the output span if device is
configured with only one control output
- from -100.0 to 100.0 of the output span if device is
configured with two control outputs (split range
excluded).
Above the value 100.0 the display shows “buñ.” meaning that
the transfer from AUTO to MANUAL is bumpless (the instrument
set for MANUAL mode the same power output used in AUTO
mode)
Xkc-1-C0.P65 5/29/02, 11:59 AM50