107
Other errors
The instrument is also capable to detect the following errors:
E.100 Error during data saving in FRAM
E.110 Error in FRAM handling
E.500 Error during auto-zero measurement
E.501 Error during zero integrator measurement
E.502 Error during reference junction measurement. NOTE:
this error may be generated by an ambient temperature
higher than 70 °C (158 °F) or lower than -20 °C (-4 °F).
When one of these errors is detected, contact your supplier.
Two errors, related with the preliminary hardware setting, are
detectable:
3. wrong position of the V301 dip switch.
8. wrong position of the V101 dip switch.
When one of these error is detected, the display blanks and the
error code is shown on most significant digit of the upper
display.
Remake V101 or V301 setting.
Xkc-1-C0.P65 5/29/02, 11:59 AM107
To Next Page
Loading...
