Erreka VIVO-D103 - User Manual

5
VIVO-D103 / ADB30
Quick installation and programming guide English
WARNING
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The most recent version of this guide and the
installation manual are available at the "Downloads" section on Erreka's website:
http://www.erreka-automation.com
The options and functions described in this guide apply for the firmware version indicated on the circuit. The
firmware, as part of a process of continuous improvement, is subject to new functionalities or upgrades being
included as a result of new versions which are not necessarily compatible with previous ones. For this reason,
some options or functions may differ or be unavailable if your firmware is older than shown in this guide.
Elements of the complete installation
Electrical wiring
A: Main power supply
B/G: Flashing light with antenna
C: Photocells (mirror)
D: Pushbutton or key switch
E: Operator (motor + limit switches)
F: Operator release
V2.0 or later

Summary

General Warning and Installation Overview

Safety and Firmware Warnings

Crucial safety warnings and firmware version considerations for installation.

Elements of Complete Installation Diagram

Visual representation of the gate installation components and wiring.

General Connections and Wiring

Control Board Connections

Details on connecting receivers, LEDs, fuses, and other components.

Limit Switch and Turning Direction

Instructions for adjusting limit switches and checking turning direction.

Programming Modes and Functions

SW2 Programming Functions (DIP3=ON)

Configuration for programming mode using SW2 when DIP3 is ON.

Total Travel Programming Procedure

Step-by-step guide for programming the gate's total travel.

Photocell Shade Function

Explanation of photocell invalidation during the closing run.

Operation Mode Selection and Setup

SW2 Operation Modes (DIP3=OFF)

Selection of various operation modes using SW2 with DIP3 OFF.

Jumpers and Potentiometers Configuration

Guidance on setting operator model jumpers and adjusting torque.

Erreka VIVO-D103 Specifications

General

Maximum motor power	100W
Protection level	IP20
Protection Degree	IP20
Operating temperature	-20ºC / +55ºC
Storage Temperature	-30ºC / +70ºC
Motor power supply	24 V AC/DC ±10%
Relative Humidity	20% to 90% (non-condensing)