4 INSTALLATION
0449 507 101
- 9 -
© ESAB AB 2017
4 INSTALLATION
The installation must be carried out by a professional.
NOTE!
Mains supply requirements
High power equipment may, due to the primary current drawn from the mains
supply, influence the power quality of the grid. Therefore connection restrictions
or requirements regarding the maximum permissible mains impedance or the
required minimum supply capacity at the interface point to the public grid may
apply for some types of equipment (see "TECHNICAL DATA" chapter). In this
case it is the responsibility of the installer or user of the equipment to ensure, by
consultation with the distrubution network operator if necessary, that the
equipment may be connected.
4.1 Location
WARNING!
Secure the equipment - particularly if
the ground is uneven or sloping.
• Place the welding power source on a level foundation.
• Make sure there is nothing to prevent the cooling.
Lifting instructions
To Next Page
Loading...
