ESAB Multimaster-260 - Page 51

51
21155
21155
21156
21156
21160
21160
21161
21161
21161
21161
21162
Drive Roll and Guide Tube Selection
Guide Tube
NAS
* Two drive rolls are required for four roll drive systems.
Wire Type
& Diameter
Roll Drive*
.023 in. (0.6 mm)
.030 in. (0.8 mm)
.035 in. (0.9 mm)
.045 in. (1.2 mm)
.030 in. (0.8 mm)
.035 in. (0.9 mm)
.040 in. (1.0 mm)
.045 in. (1.2 mm)
.052 in. (1.4 mm)
1/16 in. (1.6 mm)
5/64 in. (2.0 mm)
0558001499
0558001499
0558001498
0558001498
.030 in. (0.8 mm)
.035 in. (0.9 mm)
3/64 in. (1.2 mm)
1/16 in. (1.6 mm)
0558001499
0558001498
0558001498
0558001498
0558001497
0558001497
0558001497
21158
21158
21159
21159
Hard Wires (“V” groove)
Soft (aluminum) Wire (“U” groove)
Cored Wires (Knurled “V” groove)
0558001902
0558001903
0558001904
0558001904
SECTION 6 REPLACEMENT PARTS