Safety precautions
The Auto-Darkening welding helmet comes assembled. But before it can be used, it must be
adjusted to fit the user properly. Check battery surfaces and contacts and clean them if necessary.
Verify if the battery is in good condition and installed properly. Set up for delay time, sensitivity, and
shade number for your application.
The helmet should be stored in a cool, dry, and dark place. Remove the battery before long-time
storage.
1. This Auto-Darkening welding helmet is not suitable for laser welding.
2. Never place this helmet and Auto-Darkening filter on a hot surface.
3. Never open or tamper with the Auto-Darkening filter. There are no user-serviceable parts inside.
4. This Auto-Darkening welding helmet will not protect against severe impact hazards.
5. This helmet will not protect against explosive devices or corrosive liquids.
6. Do not make any modifications to either the filter or helmet, unless specified in this manual.
7. Do not use replacement parts other than those specified in this manual.
8. Unauthorized modifications and replacement parts will void the warranty and expose
the operator to personal injury.
9. Should this helmet not darken upon striking an arc, stop welding immediately and
contact ESAB.
10. Do not immerse the Auto-Darkening filter in water.
11. Do not use any solvents on the Auto-Darkening filter screen or helmet components.
WARNING!
Before use, read and understand the instruction manual
and follow all labels, employer´s safety practices and
To Next Page
Loading...
