13
Preparing Your Dishwasher
RINSE AID
Rinse aid is released during the dishwasher’s nal rinse to prevent water from forming droplets on your
dishes, which can leave spots and streaks. It also improves drying by allowing water to roll o the dishes.
Your dishwasher has been designed to use liquid rinse aids.
WARNING! Only use branded rinse aid suitable for use in dishwashers. Never ll the rinse aid dispenser
with any other substances (i.e. Dishwasher cleaning agent, liquid detergent). This would damage the
appliance and void the Manufacturer’s Warranty.
If the rinse-aid indicator light is illuminated (
) on the control panel, then you will need to rell the
dispenser, following the instructions below. You can always estimate the amount of rinse-aid within the
reservoir from the colour of the optical level indicator located next to the cap. When the rinse-aid reservoir
is full, the indicator will be fully dark. The size of the dark dot decreases as the rinse-aid diminishes. You
should never let the rinse aid level be less than 1/4 full.
Optical Level Indicator
Figure 8- Rinse-aid optical level indicator for reservoir.
Tip! A common complaint for all dishwashers is that dishes are coming out wet after completing its
program. Rinse aid will greatly improve drying results, but there are a number of factors which can eect
drying performance, including the crockery items you are washing. Refer to section 4.3 of this manual for
some more guidelines around this topic.
FILLING THE RINSE-AID DISPENSER
Step 1 Remove the Rinse-aid dispenser cap by screwing it in an anti-clockwise direction. Refer to Figure 9.
Figure 9- Removing the Rinse-aid dispenser cap. Figure 10- Filling the Rinse-aid reservoir.
Step 2 Carefully pour the dishwasher rinse-aid into the reservoir, whilst being careful to avoid it
overowing. Refer to Figure 10.
Tip! Wipe up any overow or spilt rinse-aid as this can lead to excessive foaming in the next dishwasher
cycle.
To Next Page
Loading...
