Esatto EDW7S - Error Codes; E1 - Water entering dishwasher exceeds time limit; E3 - Water temperature not reaching desired level; E4 - Overflow detected

User Manual
30
If there is a malfunction the dishwasher will display error codes to identify the fault.
Code Indicator Meanings Possible Causes
The Rapid
program LED
indicator ashes
repeatedly and the
buzzer sounds.
E1- Water entering the dish-
washer has exceeded the
pre-set time, or the ow of
water into the dishwasher is
restricted
Ensure that the water supply hose is un-kinked and
that the water supply tap is fully open.
The Rapid & 90
Min program LED
indicators ash
repeatedly and the
buzzer sounds.
E3- The dishwashers
on board sensors have
detected that the water
isn’t reaching the desired
temperature within the pre-
set time.
Potential malfunction of the heating element. Try
turning the appliance power o at the power point
for 15 minutes before re-starting. If issue persists,
please contact our Customer Care team
The ECO program
LED indicator
ashes repeatedly
and the buzzer
sounds.
E4- Overow. The onboard
computer has detected a
leak (correctly or incor-
rectly).
Contact our Customer Care team.
The ECO & 90
Min program LED
indicators ash
repeatedly and the
buzzer sounds.
E6- Potential component
failure.
Try turning the appliance power o at the power
point for 15 minutes before re-starting. If issue per-
sists, please contact our Customer Care team.
The ECO, 90 Min
& Rapid program
LED indicators
ash repeatedly
and the buzzer
sounds.
E7- Potential component
failure.
Try turning the appliance power o at the power
point for 15 minutes before re-starting. If issue per-
sists, please contact our Customer Care team.
WARNING! If the E4 Overow error is occurring, turn o the main water supply at the tap as a pre-caution,
before calling our Customer Care team.
Note. If there is water in the base of the dishwasher because of an overll or small leak, the water should be
removed before re-starting the dishwasher.
Error Codes