M3 x 15mm.
Electric motor.
Battery.
4) Locate the plywood battery tray to the
fuselage. Tighten the screws using machine
screws M3x15mm to secure the tray in position.
Blind nut.
M3 x 15mm.
Battery.
Speed control.
5) Attach the speed control to the side of the
motor box using two-sided tape and tie wraps.
Connect the appropriate leads from the speed
control to the motor . Make sure the leads will
not interfere with the operation of the motor .
INSTALLING THE SPINNER
Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modelling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
To Next Page
Loading...